At the centre of NodeNet

nodeDeck: one place to watch every site

nodeDeck brings in readings from your sensors, whoever made them, and shows you what matters: where every sensor is, what it's reading, and when something needs attention.

What you can measure

Vibration, tilt, crack and noise monitoring are built in, judged against the right guideline values. Beyond that, nodeDeck takes readings from any sensor that can send them.

  • Vibration
  • Tilt
  • Crack movement
  • Vibrating wire
  • Noise
  • Temperature
  • Water level
  • Air quality
  • Anything your sensor sends

Features

Everything a monitoring job needs

Sites on a map

Every site and sensor in one place, coloured by how close it is to its levels.

Dashboards

Build charts per site or sensor type, and put them on a screen in the site office.

Events

Each vibration event is kept with its waveform, frequency and verdict.

Alerts

Email and SMS when a reading crosses a level you set, and again when it clears.

Reports

Scheduled reports for a period, reviewed before they go, shared by private link.

Sensor health

Battery, signal and last reading for each sensor that reports them, with a warning when one goes quiet.

Remote settings

Change a sensor's settings and update its firmware without going to site.

Any maker's sensors

Pick a model from nodeDeck's library, or describe a new one: what it measures and how it sends readings.

Sensors

NodeNet's sensors, or yours

Built for nodeDeck

NodeNet sensors

Quill for vibration, Skew for tilt, and Chord for vibrating-wire instruments. Set up in minutes, configured and updated from nodeDeck.

QuillSkewChord

Bring your own

Other makers' sensors

LoRaWAN sensors through ChirpStack and MQTT devices through Mosquitto. Many models are already in the library, and Node-RED can bring in devices that only post over HTTP.

LoRaWANMQTT

See sensors for more, and pricing for what nodeDeck costs.

Have a site to monitor?

Tell us about your sensors and sites, and we'll show you how NodeNet fits.